The parameter for this is " rdisp/max_debug_lazy_time " the default value for which is 600 seconds.
You can change it dynamically i.e. it shall take effect without a re-start. It should be set as dynamically switchable via RZ11 -> just enter the parameter press change value -> enter new value and save.
Please do remember that changes done via RZ11 are temporary and they will be gone when the system is restarted.
You can also refer to the SAP Note : 321488 - Handling debugging sessions
# Please spare some time to put a comment, if this post was relevant for you or not. It helps me post better content.
Friday, July 17, 2009
Subscribe to:
Post Comments (Atom)
2 comments:
Hi,
Thank you for the post. I'm having difficulties debugging rfc-calls, the timeout is too short, so that debugger exits soon.
- Would this setting help increase rfc-timeout for debugging purposes ?
Thanks,
Alex
Hey Alex,
I guess it should. Its a dynamically switchable parameter so you can give it a shot without a re-start.
Also increasing the value of "rdisp/max_priv_time" will also help.
Regards,
Nitin
Post a Comment